Little by little and article we go to article incrementadno our small corner on the engines stirling.
In this occasion we have found an article with the detailed construction of the engine in makezine, web that I recommend to the whole world. I happen to translate so that you all could enjoy it.
Construction of an engine stirling.
It is a question of a machine in which it is necessary to be quite meticulous in his construction.
It uses the same skills that are described in the article, to make sure a precise cut and that it should fit to our intentions.
With a small lime we remove the rough edges of the plastic of the tarrina of the CD
To be right claraas in the marks for court in the aluminum, so that they are easy to see for the cut with the saw of drawing
We use a metal saw with the saw of drawing and cut calmly and concentrating well on the marks to obtain the circles.
To realize a central hole we have only to do a series of holes with an auger, and then we will file with a thin lime, the aluminum is very simple to work and we will not have any problem.
In this case the crankshaft of the engine was compensated less than it sets in the instructions of the digital magazine.
We find a completely detailed explanation although in English in http://www.make-digital.com/make/vol17/?pg=70&pm=2&u1=friend
If some weekend I have some time I do not discard to do my attempt and to mention to you how it has gone.
A greeting and I hope that it should serve this information to you.
0 comments:
Post a Comment